Trenz Electronic GmbH
TE0705 - Simplified carrier board based upon TE0701 (TE0705-04)
This carrier board is only for the use of Trenz Electronic modules with a standard footprint of 4 x 5 cm.
Item number VAR-827000662
Located in: Germany
This article is the replacement for the TE0705-03.
The baseboard TE0705 is a "downgraded" version from TE0701 and it provides low-cost connection and extension to Trenz Electronic modules with a standard footprint of 4 x 5 cm.
As little as possible has been changed in functionality (except the functionality that was removed).
See page "4 x 5 cm carriers" to get information about the SoMs supported by the TE0705 carrier board.
Notice
Do not access the FT2232H EEPROM using FTDI programming tools, doing so will erase normally invisible user EEPROM content and invalidate stored Xilinx JTAG license. Without this license the on-board JTAG will not be accessible any more with any Xilinx tools. Software tools from FTDI website do not warn or ask for confirmation before erasing user EEPROM content.
Key Features
- Trenz 4 x 5 module socket (3 x Samtec LSHM connectors)
- RJ45 GbE Ethernet
- Micro USB connector (Device, Host or OTG modes)
- SD Card connector
- High performance DCDC converter for local supplies
- Carrier controller Lattice MachXO2 CPLD
- 1200 Macrocell CPLD with Block RAM, Flash and PLL
- 8 User LEDs mappable to different functions
- 2 User Pushbuttons mappable to different functions
- 80 I/O's
- USB JTAG interface
- Mini USB connector
- Compatible with Xilinx tools
- Based on FT2232H USB chip
Changes from TE0701
- Pmod connectors changed to IDC headers
- FMC connector removed and replaced by two dual-row 100 mil pin-headers
- HDMI removed completely
- CL connector removed
- USB connector position changed
- 5 pin header support added on both USB interfaces
- 12V DC power input connector changed to different type
Scope of Delivery
- 1 x TE0705-04 carrier board for Trenz Electronic modules with 4 x 5 cm footprint
- 1 x Mini-Fit JR JR Receptacle 2Pol.
- 4 x Mini-Fit Female Crimp Terminal 18-24 AWG
Use with TE0715-xx-30-xx
For use with TE0715-xx-30-xx or any other 4 x 5 module that has some banks without 3.3V tolerance the I/O voltage must be changed by moving the jumper J21 to position "VADJ".It may be requried to update the CPLD on TE0705 first.
Additional Information
- Manufacturer's article number: TE0705-04
- Trenz Electronic Carrierboard TE0705 Wiki
- Support Forum
All modules produced by Trenz Electronic are developed and manufactured in Germany.
| Item ID | 100550 |
| Condition | New |
| Legacy item ID | 2590 |
| Model | TE0705-04 |
| Manufacturer | Trenz Electronic GmbH |
| Manufacturing country | Germany |
| Content | 1 piece |
| Weight | 168 g |
| Net weight | 168 g |
| Customs tariff number | 84715000 |
