Carrier board for TEM0007 Microchip PolarFire SoC module (TEB2000-01-T001)

The Trenz Electronic TEB2000 carrier board provides functionality for development, evaluation and testing purposesof Trenz 4 x 5 cm SoMs(System on Module).

The carrier board is equipped with a broad range of various components and connectors for different configuration setups and needs. On-module functional components and multipurpose I/Os of the SoM's logic are connected via board-to-board connectors to the carrier board components and connectors for easy user access.

See page "4 x 5 cm carriers" to get information about the SoMs supported by the TE0703 carrier board.

Key Features

• On Board
  • System Controller (SC) (LCMXO2-1200HC-4TG144I1))
  • Mini USB for JTAG and UART connection (FTDI FT2232H)
  • Mini USB second UART connection (FTDI FT230XQ)
  • SDIO port expander
  • 4 x User LEDs
    
    • D1, D2 connected to SC (firmware-dependent functionality)
    • D3, D4 connected to SC and 4 x 5 SoM
  • 2 x User push button
    
    • Connected to SC (firmware-dependent functionality)
    • Currently used for Hard- and Soft-Reset
  • 4 User DIP switches
    
    • Enable/disable update of the SC
    • MIO0 (accessible signal by SC and SoM)
    • 2 "mode" bits
      
      
• Interface
  • Trenz 4 x 5 SoM socket
    
    • 3 x Samtec LSHM series high-speed connectors
  • Micro SD card connector
  • 2 x VG96 backplane connectors assembly option (mounting holes and solder pads)
  • Mini or Normal USB for SoM USB-OTG connection (depends on assembly variant)
  • RJ45 GbE connector
    
    
• Power
  • Overvoltage-, undervoltage- and reversed- supply-voltage-protection
  • Barrel jack (2.1 mm) for 5V power supply input
    
    
• Size
  • 10 x 6.45 cm

Scope of Delivery

• 1 x TEB2000-01-T001 Carrier board for TEM0007 Microchip PolarFire SoC module
  
  

Note: VG96 Connector vertical (article 21545), Harting DIN41612 (female)is not included in the scope of delivery, but can be purchased as an accessory in the shop.

Info: M2.5x8 mm screws and M2.5 galvanized nuts are required for mounting the VG96 connector.

Additional Information

• Manufacturer'sarticle number: TEB2000-01-T001
• Trenz Electronic Carrierboard TEB2000 Wiki
• Support Forum