Articles fréquemment consultés
Trenz Electronic GmbH
TE0705 - Simplified carrier board based upon TE0701 (TE0705-04)
Carrier Board for 4 x 5 cm Trenz Electronic SoMs with 3 x Samtec LSHM Series Connectors, "downgraded" version from TE0701
Référence de l’article: VAR-827003695
Numéro de produit du fabricant: TE0705-04
Code douane: 84718000
Article situé / expédié de : Riedlingen, Allemagne
This article is the replacement for the TE0705-03.
The baseboard TE0705 is a "downgraded" version from TE0701 and it provides low-cost connection and extension to Trenz Electronicmodules with a standard footprint of 4 x 5 cm.
As little as possible has been changed in functionality (except the functionality that was removed).
See page "4 x 5 cm carriers" to get information about the SoMs supported by the TE0705 carrier board.
Notice
Do not access the FT2232H EEPROM using FTDI programming tools, doing so will erase normally invisible user EEPROM content and invalidate stored AMD/Xilinx JTAG license. Without this license the on-board JTAG will not be accessible any more with any AMD/Xilinx tools. Software tools from FTDI website do not warn or ask for confirmation before erasing user EEPROM content.
Key Features
- Trenz 4 x 5 module socket (3 x Samtec LSHM connectors)
- RJ45 GbE Ethernet
- Mini-Fit JR Header 2Pol. for 12V power supply (J10 connector)
- Micro USB connector (Device, Host or OTG modes)
- SD Card connector
- High performance DCDC converter for local supplies
- Carrier controller Lattice MachXO2 CPLD
- 1200 Macrocell CPLD with Block RAM, Flash and PLL
- 8 User LEDs mappable to different functions
- 2 User Pushbuttons mappable to different functions
- 80 I/O's
- USB JTAG interface
- Mini USB connector
- Compatible with Xilinx tools
- Based on FT2232H USB chip
Caution!
To power up the board over the J10 connector (Mini-Fit JR Header 2Pol.) a suitable supply cable has to be assembled with the provided accessories. Please note the polarity!
Scope of Delivery
- 1 x TE0705-04 carrier board for Trenz Electronic modules with 4 x 5 cm footprint
- 1 x Mini-Fit JR Header 2Pol.
- 4 x Mini-Fit Female Crimp Terminal 18-24 AWG
Use with TE0715-xx-30-xx
For use with TE0715-xx-30-xx or any other 4 x 5 module that has some banks without 3.3V tolerance the I/O voltage must be changed by moving the jumper J21 to position "VADJ".It may be requried to update the CPLD on TE0705 first.
Additional Information
- Manufacturer'sarticle number: TE0705-04
- Trenz Electronic Carrierboard TE0705 Wiki
- Support Forum
All modules produced by Trenz Electronicare developed and manufactured in Germany.
| Caractéristique technique | Valeur |
|---|---|
| ID de l’art. | 103209 |
| État | |
| ID de l'ancien article | 01968567848b710f8e9db29ab9f21f72 |
| Modèle | TE0705-04 |
| Fabricant | Trenz Electronic GmbH |
| Pays de fabrication | Allemagne |
| Contenu | 1 pièce |
| Poids | 218 g |
